Polycom
From CVL Wiki
(Difference between revisions)
| Line 7: | Line 7: | ||
#When finished, please change projector input back to HDMI and press "Standby" button | #When finished, please change projector input back to HDMI and press "Standby" button | ||
| − | ===Polycom | + | ===Polycom=== |
| − | ==== | + | ====Device Setup==== |
#Turn on TV (Samsung Remote) | #Turn on TV (Samsung Remote) | ||
#* TV displays Polycom camera on video source HDMI2 | #* TV displays Polycom camera on video source HDMI2 | ||
| Line 20: | Line 20: | ||
#Projector 2 mirrors Polycom display on TV (no remote) | #Projector 2 mirrors Polycom display on TV (no remote) | ||
#* Projector 2 displays Polycom camera on video source HDMI | #* Projector 2 displays Polycom camera on video source HDMI | ||
| − | # | + | #If sending computer content, plug in "POLYCOM CONTENT INPUT" cable |
| − | # | + | |
| − | # | + | ====Making a Call==== |
| + | #Press '''Home''' button | ||
| + | #Select '''Place a Call''' | ||
| + | #Enter the IP address and press '''Call''' button | ||
| + | #Remote site should answer automatically | ||
| + | |||
| + | ====Sending computer content==== | ||
| + | #Plug '''POLYCOM CONTENT INPUT''' cable into computer | ||
| + | #Press '''Content''' button and select '''Computer''' | ||
| + | #* You should see content on Projector 1 | ||
| + | |||
==302 Conference Room== | ==302 Conference Room== | ||
Revision as of 11:06, 3 February 2014
Contents |
457 Conference Room Directions
Local Computer Content (No Polycom)
- Turn on Projector 1 over conference table (Sharp remote)
- Change projector input to "Computer 1" (Sharp remote)
- Plug "VGA INPUT" cable into computer
- When finished, please change projector input back to HDMI and press "Standby" button
Polycom
Device Setup
- Turn on TV (Samsung Remote)
- TV displays Polycom camera on video source HDMI2
- Turn on Projector 1 over conference table (Sharp Remote)
- Projector 1 displays Polycom computer content on video source HDMI
- Projector 1 is also speaker source for room
- Turn on Polycom (Polycom remote)
- Point remote at camera
- Be patient, boot up takes a few minutes.
- Polycom home screen is on TV or Projector 2
- Projector 2 mirrors Polycom display on TV (no remote)
- Projector 2 displays Polycom camera on video source HDMI
- If sending computer content, plug in "POLYCOM CONTENT INPUT" cable
Making a Call
- Press Home button
- Select Place a Call
- Enter the IP address and press Call button
- Remote site should answer automatically
Sending computer content
- Plug POLYCOM CONTENT INPUT cable into computer
- Press Content button and select Computer
- You should see content on Projector 1
302 Conference Room
4th Floor
Troubleshooting
- Check input channel of projector
654 Whittemore
Polycom only
IP: 128.173.89.184
457 Whittemore Polycom only IP: 128.173.90.254
460 Durham Polycom only IP: 128.173.92.180
